You’ll need all the same materials as used in the pinning technique but you’ll replace the pins with a heavy thread and needle. This method is great to use when you have a finished project with not a lot of excess fabric around the edges - meaning you don’t have a lot to wrap and therefore be able to pin securely. Lastly, attach the picture frame hook to the back of the frame and you’re ready to display your spectacular cross stitch project! THE LACING METHOD Place the piece into the frame - this should fit nice and snugly! Stick the paper to the back of the piece using double sided tape or hot glue.

When it comes to the corners you can either simply fold over the edges - like you would with a parcel or fold the corners in at an angle before taping the excess on the corners to the back.

Once you have pinned the whole length of each of the two longest edges, fold the fabric over the two smallest edges and begin pinning, starting from the centre, again stopping a little before you reach each corner. You can check this every now and then by viewing the front. Start from the centre points along each edge, leaving gaps of the same size between each pin and stopping a little before you reach each corner.īe sure to keep the tension on the fabric - but do not stretch it too much. Begin pushing the pins into the sides of the board through your piece. Fold the two longest edges of fabric excess over onto the back of the board. Next, flip the pinned fabric and board over. You could also use a ruler at this point to check that it’s just right.

Remember to use an erasable fabric pen when marking your fabric, not a regular pen! Put a pin through the marked centre of your cross stitch piece and then through the centre of your board, eyeing it up to make sure it is centred and straight. The quickest way to do this is to draw two lines diagonally, each stretching from one corner to the opposite corner. To get started, you'll need to mark the centre of both the board and your finished piece. You’ll need a picture frame, a piece of foam core that isn’t too thick (around 1/4 or 1/8 of an inch cut to the size of the opening at the back of your frame), some small pins, craft paper (cut a little larger than the opening on the back of your frame) and some double sided sticky tape or hot glue gun.īecause you're not going to be using the backing that came with the picture frame, you'll also need some picture hangers that you can attach to the back of the frame.

This is probably the most popular technique to use when mounting and creates a lovely finish, which some choose to display without a frame. So, you’ve finished a beautiful cross stitch piece and can’t wait to proudly display it but the thought of framing it yourself may feel a little daunting! Here are two easy cross stitch framing techniques that will show off your work in all it’s glory. How to Frame Your Finished Cross Stitch Project

Cross stitch finishing techniques